I’ve finally been connected to a fiber connection 2,5/1Gbps! 🥳 Now I want to share my connection with my neighbor and so I’ve installed 3 PCIx dual 1GB nic (I’m out of PCIe slots 🤷‍♂️).

The connections comes from my OPNsense to the server (Proxmox) via a 10Gbps fiber connection.

I want OPNsense to take car of firewalling dividing the neighbor networks with VLANs. The OPNsense part is done and working, I need to assign to each of the 6 1Gbps NIC each VLAN.

I’ve tagged the traffic going into the server via the fiber connection, but now how can I assign each VLAN to each NIC? Thanks!

Edit: Proxmox has nothing to do in the equation, it just happens to be on the same server where the NICs are.

  • peregus@lemmy.worldOPEnglish
    1·
    6 months ago

    I don’t need to assign VLANs to VMs, I need to assign them to 6 phisical NICs (tha fact that they are installed in the same machine where there is Proxmox is irrelevant).

    • 4am@lemm.eeEnglish
      3·
      6 months ago

      If Proxmox is already installed on the machine, how are you running OPNSense? If it’s not bare metal, it’s a VM, and if it’s a VM it needs Proxmox’s virtual NICs to be VLAN aware, unless you are doing PCI pass through of the entire network card.

      • HybridSarcasm@lemmy.worldMEnglish
        1·
        6 months ago

        Would they have to be VLAN aware if the switch port was already tagged AND if OP doesn’t care to consider untagged traffic ?

      • peregus@lemmy.worldOPEnglish
        1·
        6 months ago

        OPNsense is in one PC (and it only works as router/firewall), Proxmox is on another PC with all the NICs and Proxmos and it will also work as switch.